R2D2 HTTP API
Any command from the R2D2 API can be accessed through a HTTP Interface.
It has the following syntax:
| Syntax: | http://[user:password@]IP_Address[:Port_Number]/cgi-bin?command=R2D2Command&arg1=val1&arg2=val2...&argN=v |
| - User:password are user & password to connect to the Robot
- IP_Address is the TCP/IP address of the Robot, Port is the port used to access the R2D2 API - R2D2Commmand is the R2D2 API command to be executed - arg1 to argN depend on the arguments needed for the R2D2 API command entered. Argument between brackets are optionals. | |
| Examples: | If Robot's credentials are user=root and password=admin, at IP Address 192.168.1.1 with port 8000:
|
In order to allow the HTTP interface to work, it has to be enabled by the following command (through SSH):
reg add services/gsmrobotd/parameters /v HTTPListeningPort /t REG_DWORD /d 80
It sets the HTTP ListingPort to 80, or any desired and available value.
reg add services/gsmrobotd/parameters /v HTTPSListeningPort /t REG_DWORD /d 443
It sets the HTTPS ListingPort to 443, or any desired and available value. And the following line saves the modification on disk.
reg regsave
Then to take into account the changes the following commands must be entered:
sc stop gsmrobotd
sc stop gsmuxsvc
sc start gsmuxsvc
sc start gsmrobotd
The following command can then be used to check if the configuration is correct:
reg query services/gsmrobotd/parameters /v HTTPListeningPort
reg query services/gsmrobotd/parameters /v HTTPSListeningPort
It will either return the HTTP or the HTTPS Listening port depending on the command above entered.